HP 6125G - Configuring Ipv6 Static Multicast MAC Address Entries; Configuring MLD Snooping Port Functions

213
For more information about static joining, see "Configuring static ports."
Configuration procedure
To specify the version of MLD snooping:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Specify the version of MLD
snooping.
mld-snooping version
version-number
Version 1 by default
Configuring IPv6 static multicast MAC address entries
In Layer-2 multicast, a Layer-2 IPv6 multicast protocol (such as MLD snooping) can dynamically add IPv6
multicast MAC address entries. Or, you can manually configure IPv6 multicast MAC address entries.
Configuration guidelines
• The configuration that you make in system view is effective on the specified interfaces. The
configuration that you make in interface view is effective only on the current interface.
• Any legal IPv6 multicast MAC address except 3333-xxxx-xxxx (where x represents a hexadecimal
number from 0 to F) can be manually added to the MAC address table. IPv6 multicast MAC
addresses are the MAC addresses whose the least significant bit of the most significant octet is 1.
Configuration procedure
To configure an IPv6 static multicast MAC address entry in system view:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address interface interface-list
vlan vlan-id
No static multicast MAC address
entries exist by default.
To configure an IPv6 static multicast MAC address entry in interface view:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
In Ethernet interface view or Layer
2 aggregate interface view, the
configuration is effective on only
the current interface.
3. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address vlan vlan-id
No static multicast MAC address
entries exist by default.
Configuring MLD snooping port functions
Before you configure MLD snooping port functions, complete the following tasks: