HP 6125G Configuration Guide

226
Ste
p
Command
Remarks
3. Set the DSCP value for MLD
messages.
dscp dscp-value
By default, the DSCP value in MLD
messages is 48.
Displaying and maintaining MLD snooping
Task Command
Remarks
Display MLD snooping group
information.
display mld-snooping group [ vlan
vlan-id ] [ slot slot-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display information about the hosts
tracked by MLD snooping.
display mld-snooping host vlan
vlan-id group ipv6-group-address
[ source ipv6-source-address ] [ slot
slot-number ] [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Display IPv6 static multicast
MAC address entries.
display mac-address
[ mac-address [ vlan vlan-id ] |
[ multicast ] [ vlan vlan-id ]
[ count ] ] [ | { begin | exclude
| include } regular-expression ]
Available in user view.
Display statistics for the MLD
messages learned through MLD
snooping.
display mld-snooping statistics [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Remove dynamic group entries of
a specified MLD snooping group
or all MLD snooping groups.
reset mld-snooping group
{ ipv6-group-address | all } [ vlan
vlan-id ]
Available in user view.
This command works only on an
MLD snooping–enabled VLAN, but
not in a VLAN with MLD enabled
on its VLAN interface.
This command cannot remove the
static group entries of MLD
snooping groups.
Clear statistics for the MLD
messages learned through MLD
snooping.
reset mld-snooping statistics Available in user view.
MLD snooping configuration examples
IPv6 group policy and simulated joining configuration example
Network requirements
As shown in Figure 62, MLDv1 runs on Router A, MLDv1 snooping required on Switch A, and Router A
acts as the MLD querier on the subnet.
The receivers, Host A and Host B can receive IPv6 multicast traffic addressed to IPv6 multicast group
FF1E::101 only.

HP 6125G Specifications

General

Brand	HP
Model	6125G
Category	Switch
Language	English