HP 6125G - Configuring Ipv6 Multicast VLAN Ports; Displaying and Maintaining Ipv6 Multicast VLAN

243
For more information about the port link-type, port hybrid pvid vlan, and port hybrid vlan commands,
see Layer 2—LAN Switching Command Reference.
Configuring IPv6 multicast VLAN ports
In this approach, you configure a VLAN as an IPv6 multicast VLAN and assign user ports to it. You can
do this by either adding the user ports in the IPv6 multicast VLAN or specifying the IPv6 multicast VLAN
on the user ports. These two methods provide the same result.
Configuration guidelines
• You cannot configure an IPv6 multicast VLAN on a device with multicast routing enabled.
• The VLAN to be configured as an IPv6 multicast VLAN must exist.
• A port can belong to only one IPv6 multicast VLAN.
Configuration procedure
To configure IPv6 multicast VLAN ports in IPv6 multicast VLAN view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the specified VLAN
as an IPv6 multicast VLAN
and enter IPv6 multicast
VLAN view.
multicast-vlan ipv6 vlan-id
No IPv6 multicast VLAN
configured by default.
3. Configure the ports as
member ports of the IPv6
multicast VLAN.
port interface-list
By default, an IPv6 multicast
VLAN has no member ports.
To configure IPv6 multicast VLAN ports in interface view:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure the specified
VLAN as an IPv6 multicast
VLAN and enter IPv6
multicast VLAN view.
multicast-vlan ipv6 vlan-id
Not an IPv6 multicast VLAN by
default.
3. Return to system view.
quit N/A
4. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
Use either command.
5. Configure the ports as
member ports of the IPv6
multicast VLAN.
port multicast-vlan ipv6 vlan-id
By default, a user port does not
belong to any IPv6 multicast VLAN.
Displaying and maintaining IPv6 multicast VLAN