Remarks
4. Set the maximum response
delay for MLD general
queries.
mld-snooping max-response-time
interval
10 seconds by default
5. Set the MLD last-member
query interval.
mld-snooping
last-listener-query-interval interval
Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Configure the source IPv6
address of MLD general
queries.
mld-snooping general-query
source-ip { ipv6-address |
current-interface }
FE80::02FF:FFFF:FE00:0001 by
default
4. Configure the source IPv6
address of MLD
multicast-address-specific
queries.
mld-snooping special-query
source-ip { ipv6-address |
current-interface }
FE80::02FF:FFFF:FE00:0001 by
default
IMPORTANT:
The source IPv6 address of MLD query messages might affect MLD querier election within the subnet.
Configuring MLD snooping proxying
Before you configure MLD snooping proxying in a VLAN, complete the following tasks:
• Enable MLD snooping in the VLAN.
• Determine the source IPv6 address for the MLD reports sent by the proxy.
• Determine the source IPv6 address for the MLD done messages sent by the proxy.
Enabling MLD snooping proxying
The MLD snooping proxying function works on a per-VLAN basis. After you enable the function in a
VLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router in the
VLAN.
To enable MLD snooping proxying in a VLAN:
Ste