HP 6125G - Configuration Prerequisites; Configuring Ipv6 MBGP Route Preferences; Configuring the Default Local Preference; Configuring the MED Attribute

352
• IPv6 MBGP protocol preference
• Default LOCAL_PREF attribute
• MED attribute
• NEXT_HOP attribute
• AS_PATH attribute
Configuration prerequisites
Before you configure IPv6 MBGP route attributes, complete the following tasks:
• Enable IPv6.
• Configure basic IPv6 MBGP functions.
Configuring IPv6 MBGP route preferences
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Configure preferences for
external, internal, and local
IPv6 MBGP routes.
preference { external-preference
internal-preference
local-preference | route-policy
route-policy-name }
Optional.
The default preference values of
external, internal, and local routes
are 255, 255, and 130,
respectively.
Configuring the default local preference
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Set the default local
preference.
default local-preference value
Optional.
By default, the default local
preference is 100.
Configuring the MED attribute
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A