HP 6125G - Page 161

To Next Page

To Previous Page

150

Figure 49 Network diagram

Device Interface IP address Device Interface IP address

Switch A Vlan-int100 10.110.1.1/24

Switch D

Vlan-int300 10.110.5.1/24

Vlan-int101 192.168.1.1/24

Vlan-int101 192.168.1.2/24

Vlan-int102 192.168.9.1/24 Vlan-int105 192.168.4.2/24

Switch B Vlan-int200 10.110.2.1/24

Switch E

Vlan-int104 192.168.3.2/24

Vlan-int103 192.168.2.1/24

Vlan-int103 192.168.2.2/24

Switch C Vlan-int200 10.110.2.2/24 Vlan-int102 192.168.9.2/24

Vlan-int104 192.168.3.1/24

Vlan-int105 192.168.4.1/24

Configuration procedure

1. Configure the IP address and subnet mask for each interface as per Figure 49. (Details not shown.)

2. Configure OSPF on the switches in the PIM-SSM domain to make sure they are interoperable at the

network layer. (Details not shown.)

3. Enable IP multicast routing, IGMP and PIM-SM:

# Enable IP multicast routing on Switch A, enable IGMPv3 on VLAN-interface 100, and enable

PIM-SM on each interface.

<SwitchA> system-view

[SwitchA] multicast routing-enable

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] igmp enable

[SwitchA-Vlan-interface100] igmp version 3

[SwitchA-Vlan-interface100] pim sm

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] pim sm

Ethernet

EthernetEthernet

N1N2

Vlan-int101

Other manuals for HP 6125G