HP 6125G - Page 352

341
Figure 94 Network diagram
Device Interface IPv6 address
Device
Interface IPv6 address
Switch A Vlan-int100 1001::1/64 Switch D Vlan-int300 4001::1/64
Vlan-int101 1002::1/64
Vlan-int101 1002::2/64
Vlan-int102 1003::1/64
Vlan-int105 4002::1/64
Switch B Vlan-int200 2001::1/64 Switch E Vlan-int104 3001::2/64
Vlan-int103 2002::1/64
Vlan-int103 2002::2/64
Switch C Vlan-int200 2001::2
/
64
Vlan-int102 1003::2/64
Vlan-int104 3001::1/64 Vlan-int105 4002::2/64
Configuration procedure
1. Enable IPv6 forwarding on each switch and configure the IPv6 address and prefix length for each
interface as per Figure 94. (Details not
shown.)
2. Configure OSPFv3 on the switches in the IPv6 PIM-SSM domain to make sure the switches are
interoperable at the network layer. (Details not shown.)
3. Enable IPv6 multicast routing, MLD and IPv6 PIM-SM:
# Enable IPv6 multicast routing on Switch A, enable MLDv2 on VLAN-interface 100, and enable
IPv6 PIM-SM on each interface.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] mld version 2
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
Ethernet
EthernetEthernet
N1N2
Vlan-
i
nt
101
Vlan-
i
nt10
1