Table 8-2 HP Jetdirect Configuration
Message Description
STATUS Current state of the HP Jetdirect print server.
I/O CARD READY, or READY: The HP Jetdirect print server has successfully connected
to the network and is awaiting data.
I/O CARD INITIALIZING, or INITIALIZING: The HP Jetdirect print server is initializing
the network protocols. For more information, see the status line for each protocol on the
configuration page.
I/O CARD NOT READY, or ERROR: There is a problem with the print server or its
configuration.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-13 Error Messages on page 140.
MODEL NUMBER The product number of the HP Jetdirect print server (for example, J7961G)
HARDWARE ADDRESS The 12-digit hexadecimal network hardware (MAC) address of the HP Jetdirect print
server installed in the printer or device. This address is assigned by the manufacturer.
FIRMWARE VERSION The firmware revision number of the HP Jetdirect print server currently installed in the
printer.
LAA The Locally Administered Address (LAA) identifies the user-specified LAN hardware
address of a print server, which may be required by some network adiministrators. The
default address is the print server's factory-default LAN hardware address.
PORT CONFIG Identifies the link configuration of the RJ-45 port on the HP Jetdirect wired Ethernet print
server:
10BASE-T HALF: 10 Mbps, half-duplex
10BASE-T FULL: 10 Mbps, full-duplex
100TX HALF: 100Mbps, half-duplex
100TX-FULL: 100Mbps, full-duplex
1000T-FULL: 1000 Mbps, full-duplex
UNKNOWN: The print server is in an initialization state.
DISCONNECTED: A network connection has not been detected. Check network cables.
AUTO NEGOTIATION Identifies whether IEEE 802.3u Auto-negotiation on the HP Jetdirect 10/100/1000T port
is enabled (ON) or disabled (OFF).
ON (default): The HP Jetdirect print server will attempt to automatically configure itself
onto the network at the proper speed (10, 100, 1000 Mbps) and mode (half or full
duplex). Auto-negotiation is enabled after a cold reset.
OFF: You must manually configure the speed and mode using the Jetdirect menu from
the printer's control panel. If Auto-negotiation is off, the settings must match those of
the network for proper operation.
MANUFACTURING ID The manufacturing identification code for use by HP online support personnel.
S/N The serial number of the HP Jetdirect print server.
DATE MANUFACTURED Identifies the date of manufacture of the HP Jetdirect print server.
130 Chapter 8 HP Jetdirect Configuration Pages ENWW
To Next Page
Loading...
Need help?
General
