IPX/SPX Protocol Information
Information in this section of the Jetdirect configuration page is described in Table 8-9 IPX/SPX
Configuration Information on page 137. For error messages, see Table 8-13 Error Messages
on page 140.
Table 8-9 IPX/SPX Configuration Information
Message Description
STATUS Indicates the current IPX/SPX protocol status.
READY: Indicates the HP Jetdirect print server is awaiting data over IPX/SPX.
DISABLED: Indicates that IPX/SPX was manually disabled.
INITIALIZING: Indicates that the print server is registering the node address or name.
An additional status message may also be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-13 Error Messages on page 140.
PRIMARY FRAME TYPE Specifies the frame type selection on the Jetdirect print server.
AUTO SELECT: The print server automatically senses and limits the frame type to the
first one detected.
EN_8023: Limits the frame type to IPX over IEEE 802.3 frames. All others will be
counted and discarded.
EN_II: Limits the frame type to IPX over Ethernet frames. All others will be counted and
discarded.
EN_8022: Limits the frame type to IPX over IEEE 802.2 with IEEE 802.3 frames. All
others will be counted and discarded.
EN_SNAP: Limits the frame type to IPX over SNAP with IEEE 802.3 frames. All others
will be counted and discarded.
NETWORK
FRAME TYPE
RCVD
The first column (Network) indicates the network number associated with a protocol
frame type used for communication between a server and the HP Jetdirect print server.
UNKNOWN: Indicates that the HP Jetdirect print server is still trying to determine which
network number to use.
The second column (Frame Type) identifies the frame type used with the associated
network number: EN_8023, EN_8022, EN_II, EN_SNAP. Unless a specific frame type
has been manually configured, the print server automatically determines the protocol
frame type by listening to the network data being transferred over the network.
DISABLED: Indicates that a specific frame type for that network has been manually
configured.
The third column (RCVD) indicates how many packets have been received for each
frame type.
Novell/NetWare Parameters
Information in this section of the Jetdirect configuration page is described in Table 8-10 Novell/NetWare
Configuration Information on page 138. For error messages, see Table 8-13 Error Messages
on page 140.
ENWW HP Jetdirect Configuration Page 137
To Next Page
Loading...
