Error Code and Message Description
●
Rebind time is less than, or equal to, the Renew time.
●
The lease duration is less than, or equal to, the Rebind time.
F1 TRYING TO CONNECT TO
SERVER
The HP Jetdirect print server is trying to connect to the NetWare server(s). This is a
normal message. Wait until either the connection is established or another status
message appears.
F2 TFTP IN PROGRESS The print server is attempting to use TFTP to obtain TCP/IP configuration settings over
the network.
F3 BOOTP/RARP IN PROGRESS The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
F4 BOOTP/DHCP IN PROGRESS The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
HP Jetdirect Security Page
If the HP Jetdirect print server supports IPsec, an enhanced Security page can be printed from the
Jetdirect menu accessed through the printer control panel. A typical Security page is illustrated below.
To print the HP Jetdirect Security Page:
1. On the printer control panel, navigate to the HP Jetdirect menus.
2. In the Jetdirect menus, locate and select the Security menu item.
3. In the Security, locate and select Print Sec Page . (This item will appear only if IPsec is supported
by the print server.)
4. Select Yes. The security page will print.
Table 8-13 Error Messages (continued)
146 Chapter 8 HP Jetdirect Configuration Pages ENWW
To Next Page
Loading...
Need help?
General
