CAUTION: Using Telnet to manually set an IPv4 address will override dynamic IP configuration
(such as BOOTP, DHCP, or RARP), resulting in a static configuration. In a static configuration,
the IP values are fixed and the operation of BOOTP, DHCP, RARP and other dynamic
configuration methods may no longer function.
Whenever you are manually changing an IP address, you should also re-configure the subnet
mask and default gateway at the same time.
A Typical Telnet Session
Initiating a typical Telnet session is illustrated below.
To set configuration parameters, you must set up a Telnet session from your system to the HP Jetdirect
print server.
1. Type the following at the system prompt:
telnet <IP address>
where <IP address> is the IP address listed on the Jetdirect configuration page. See
HP Jetdirect
Configuration Pages on page 127.
2. A connection to the HP Jetdirect print server will be displayed. If the server responds with
“connected to IP address”, press Enter twice to make sure that the Telnet connection is
initialized.
3. If prompted for a user name and password, enter the correct values.
42 Chapter 3 TCP/IP Configuration ENWW
To Next Page
Loading...
Need help?
General
