interlock: (or interlock-mode:)
Specifies whether an acknowledgement (ACK) on all TCP packets is required before the printer is allowed to close a Port
9100 print connection. A Port Number and Option value are specified. For current HP Jetdirect print servers, the Port
Number is 1. Option value 0 (default) disables interlock, 1 enables. For example, “interlock 1 1” specifies Port 1,
interlock enabled.
buffer-packing: (or packing:)
Enables or disables buffer packing for TCP/IP packets.
0 (default): is normal, the data buffer is packed before sending to the printer.
1: disables buffer packing, data is sent to the printer as it is received.
write-mode:
Controls the setting of the TCP PSH flag for device-to-client data transfers.
0 (default): disables this option, flag is not set.
1: all-push option. The push bit is set in all data packets.
mult-tcp-conn:
Enables or disables multiple TCP connections.
0 (default): allows multiple connections.
1: disables multiple connections.
TCP/IP Raw Print Ports
raw-port: (or addrawport:)
Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to 9000, which are application-dependent.
TCP/IP Access Control
allow: netnum [mask]
Makes an entry into the host access list stored on the HP Jetdirect print server. Each entry specifies a host or network of
hosts that are allowed to connect to the printer. The format is “allow: netnum [mask]” where netnum is a network
number or host IP address, and mask is an address mask of bits applied to the network number and host address to verify
access. Up to 10 access list entries are allowed. If there are no entries, all hosts are permitted access. For example,
allow: 192.0.0.0 255.0.0.0 allows hosts on network 192.
allow: 192.168.1.2 allows a single host. In this case, the default mask 255.255.255.255 is assumed and is not
required.
allow: 0 This entry clears the host access list.
For additional information, see
Security Features (V.36.xx) on page 113.
TCP/IP Other Settings
syslog-config:
Enables or disables syslog server operation on the print server: 0 disables, 1 (default) enables.
syslog-svr: (or syslog-srv:)
The syslog server's IP address. It specifies the server that the HP Jetdirect print server sends syslog messages to.
Table 3-2 TFTP Configuration File Parameters (continued)
30 Chapter 3 TCP/IP Configuration ENWW
To Next Page
Loading...
Need help?
General
