HP 635n - JetDirect IPv6/IPsec Print Server - Page 64

appletalk
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server (if
supported).
0 disables.
1 (default) enables.
For example,
appletalk 0 will disable AppleTalk operation
NOTE: HP Jetdirect 635n print servers: except for TCP/IP, network protocols
are disabled by factory default.
Name
(Read-only parameter) The name of the printer on the AppleTalk network. A number after
the name indicates that there are multiple devices with this name, and this is the Nth
instance of the name.
Print Type
(Read-only parameter) Specifies the AppleTalk network printer type reported by the
Jetdirect print server. Up to three print types may be reported.
Zone (Read-only parameter) The name of the AppleTalk network zone on which the printer is
located.
Phase
(Read-only parameter) AppleTalk phase 2 (P2) is pre-configured on the HP Jetdirect print
server.
Status
(Read-only parameter) Indicates the current AppleTalk configuration status.
READY: Indicates the HP Jetdirect print server is awaiting data.
DISABLED: Indicates that AppleTalk was manually disabled.
INITIALIZING: Indicates that the print server is registering the node address or name.
An additional status message may also be displayed.
DLC/LLC
dlc/llc-config
Enables or disables DLC/LLC protocol operation on the print server (if supported).
0 disables.
1 (default) enables.
For example
dlc/llc-config 0 will disable DLC/LLC operation.
NOTE: HP Jetdirect 635n print servers: except for TCP/IP, network protocols
are disabled by factory default.
strict-8022
Controls DLC/LLC protocol interpretation:
0 (default): disables, that is, provides loose interpretation.
1: enables, that is, provides strict interpretation).
Other
upgrade
To configure one or more Jetdirect print servers with the name and location of a firmware
upgrade file.
Table 3-3 Telnet Commands and Parameters (continued)
54 Chapter 3 TCP/IP Configuration ENWW