65
Link: ADM - administratively down; Stby - standby
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
BAGG1 DOWN auto A A 1
Table 15 Command output
Bridge-Aggregation1/Route-
Aggregation1 current state
Layer 2/Layer 3 interface status:
DOWN (Administratively)—Interface is shut down administratively with
the shutdown command.
DOWN—Interface is up administratively, but down physically (possibly
because no physical link is present or the link is faulty).
UP—The Ethernet interface is up both administratively and physically.
Unknown-speed mode, unknown-
duplex mode
Interface speed and duplex mode are unknown.
Last clearing of counters
Time when the reset counters interface command was last used to clear
the interface statistics.
Never indicates the reset counters interface command has never been
used on the interface since the device’s startup.
Last 300 seconds input/output
Average input/output rate over the last 300 seconds.
Statistics of all packets received/sent on the interface.
Statistics of all normal packets received/sent on the interface.
Line protocol current state
Link layer state of the interface.
Internet protocol processing
IP packet processing.
Disabled indicates that IP packets cannot be processed.
For an interface configured with an IP address, this field changes to
Internet Address is.
Output queue : (Urgent queuing :
Size/Length/Discards)
Output queue (current message number in the urgent queue/ maximum
number of messages allowed in the urgent queue/number of discarded
messages).
Output queue : (Protocol queuing
: Size/Length/Discards)
Output queue (current message number in the protocol queue/
maximum number of messages allowed in the protocol queue/number
of discarded messages).
Output queue : (FIFO queuing :
Size/Length/Discards)
Output queue (current message number in the FIFO queue/ maximum
number of messages allowed in the FIFO queue/number of discarded
messages).
The brief information of interfaces
under route mode
Brief information about Layer 3 interfaces.
The brief information of interfaces
under bridge mode
Brief information about Layer 2 interfaces.