Table 27 Stacked Switch and Stacking Module LED Error Indicators (continued)
See
Diag
Tips
Back side of chassis
Port LED
Mode/StatusChassis Status
Global Status
LED
Stacking Port
Stacking
Module
UsrBack LED
3Slow Flash
Orange
Slow Flash
Orange
Slow Flash
Green -
Member
Solid GreenSlow Flash
Orange
Slow Flash
Orange
Fast flash
Green -
Commander
Solid Green -
Member with
good stacking
connection
Slow Flash
Orange -
Member with
poor stacking
connection
4OffSlow Flash
Orange
OffSolid GreenSlow Flash
Orange
Slow Flash
Orange
5 & 6Slow Flash
Orange, if the
link is broken.
Slow Flash
Orange, if the
link is broken.
Slow Flash
Green -
Member
Solid GreenSlow Flash
Orange
Slow Flash
Orange
Fast Flash
Green -
Commander
Slow Flash
Orange -
Member in
other fragment
7Solid GreenSolid GreenSlow Flash
Green -
Member
Solid GreenOffSolid Green
Fast Flash
Green -
Commander
8Solid GreenSolid GreenSlow Flash
Green -
Member
Solid GreenOffSolid Green
Fast Flash
Green -
Commander
Table 28 Diagnostic Tips for Stack Errors:
SolutionProblemTip
Stacking is disabled on the switch.
1
1. Connect a console cable to the switch and establish
a console session, as described in 10. (Optional)
Connect a Management console
2. From the CLI config context, enter the command
stacking enable.
3. Recheck the switch LEDs:
• Stacking Port LED back to Solid green.
• Port LED in user mode are all in green color.
74 Troubleshooting
To Next Page
Loading...
