3. Remove the flex card and cable (3) from the computer.
To install the flex card, reverse the removal procedure.
Audio board
To remove the audio board, use this procedure and illustration.
Before removing the audio board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 20).
2. Remove the access panel (see Access panel on page 21).
Remove the audio board:
1. Remove Torx screw (1) that secures the board to the rear of the computer.
2. Disconnect the audio board cable from the system board connector labeled HDSET (2).
3. Remove the audio board and cable (3) from the computer.
52
Chapter 4 Removal and replacement procedures
To Next Page
Loading...
