Solid-state drive
To remove the solid-state drive, use these procedures and illustrations.
For a list of available solid-states drives, see Computer major components on page 7.
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 20).
2. Remove the access panel (see Access panel on page 21).
3. Remove any expansion cards that block access to the drive (see Expansion cards on page 31).
Remove the solid-state drive:
1. Use the following illustration to determine drive locations:
(1) Primary solid-state drive
(2) Secondary solid-state drive
38
Chapter 4 Removal and replacement procedures
To Next Page
Loading...
