HP J8697A Advanced Traffic Management Guide

4-10
Switch Meshing
Configuring Switch Meshing
Figure 4-8. After Saving a Mesh Configuration Change, Reboot the Switch
8. Press [0] to return to the Main menu.
9. To activate the mesh assignment(s) from the Main menu, reboot the
switch by pressing the following keys:
a. [6] (for Reboot Switch)
b. Space bar (to select Yes).
c. 13 (to start the reboot process).
(The switch cannot dynamically reconfigure ports to enable or disable mesh-
ing, so it is always necessary to reboot the switch after adding or deleting a
port in the switch mesh.)
The asterisk indicates
that you must reboot
the switch to cause the
Mesh configuration
change to take effect.

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2