HP J8697A Advanced Traffic Management Guide

8-8
Classifier-Based Software Configuration
Traffic Classes
< source-address > < destination-address >
Define the source IP address
(SA) and destination
IP address (DA) that a packet must contain to match
a match/ignore statement in an IPv4 or IPv6 traffic
class. Note that both the source and destination
address parameters are required entries in a match/
ignore statement.
Valid values for
< source-address > and < destination-
address
> are as follows:
• any
— Matches IPv4 or IPv6 packets from, or
destined to, any SA or DA.
• host
< SA | DA > — Matches only packets from a
specified IPv4 or IPv6 host address. Use this
match criterion when you want to match IP
packets from only one SA/DA.
• SAv4 mask | DAv4 mask
— Matches packets received
from, or destined to, a subnet or a group of IP4
addresses defined by the IPv4 mask. Enter an IPv4
mask in dotted-decimal format for an IPv4
address (for example, 10.28.31.1 0.0.0.255).
See “Using CIDR Notation for IPv4/IPv6
Addresses” on page 8-20 for information on how
IPv4 mask bit sets define a match.
Note that an IPv6 address and mask are not
supported as <SAv6 mask> and <DAv6 mask>
match criteria.)

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2