4. Insert the new glass into the frame.
5. Add the bottom glass and then the frame, securing it with four screws.
Reassemble the fusing-lamp module
The following steps provide the complete procedure for this topic.
■
See Reassemble the fusing-lamp module on page 132.
Finish the replacement
The following steps provide the complete procedure for this topic.
1. Close the top cover.
2. Ensure that all windows, covers, and doors are closed and remain in their original positions.
3. Turn on the printer.
Replace a fusing-lamp internal glass
Prepare for replacement
The following steps provide the complete procedure for this topic.
1. Ensure that you have the fusing lamp glass kit.
2. Ensure that the printer is not printing.
3. If a job has just been printed, wait about 20 minutes for the printer to cool down.
4. You are recommended to wear gloves and mask.
5. Ensure that all windows, covers, and doors are closed and remain in their original positions.
6. Turn off the printer.
Remove the fusing-lamp module
The following steps provide the complete procedure for this topic.
Table 11-23 Warning labels
Risk of burns Crush hazard Risk of trapped
finger
s
Hazardous moving
part
Light radiation
hazard
Electric shock
hazard
For more safety information, see Safety precautions on page 4
■
See Remove the fusing-lamp module on page 127.
Replace the fusing lamp
The following steps provide the complete procedure for this topic.
260 Chapter 11 Hardware maintenance
To Next Page
Loading...