To Next Page

To Previous Page

7-5

Interface Access and System Information

Interface Access: Console/Serial Link, Web, and Telnet

CLI: Modifying the Interface Access

Interface Access Commands Used in This Section

Listing the Current Console/Serial Link Configuration. The following

command lists the current interface access parameter settings.

Syntax: show console

This example shows the switch’s default console/serial configuration.

Note The serial connection for the 2510 switch is an RJ45 port located on the left

front panel of the switch.

Figure 7-2. Listing of Show Console Command

Reconfigure Inbound Telnet Access. In the default configuration,

inbound Telnet access is enabled.

Syntax: [no] telnet-server

To disable inbound Telnet access:

ProCurve(config)# no telnet-server

show console below

[no] telnet-server below

[no] web-management page 7-6

console page 7-6

local terminal mode page 7-8

Interface Access

Enable/Disable

Console Control

Options

Event Log Event

Types To List

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General