To Next Page

To Previous Page

3-5

Using the Menu Interface

Starting and Ending a Menu Session

Figure 3-1. The Main Menu with Manager Privileges

For a description of Main Menu features, see “Main Menu Features” on page

3-7.

Note To configure the switch to start with the menu interface instead of the CLI, go

to the Manager level prompt in the CLI, enter the setup command, and in the

resulting display, change the Logon

Default parameter to Menu. For more

information, see the Installation and Getting Started Guide you received

with the switch.

How To End a Menu Session and Exit from the Console:

The method for ending a menu session and exiting from the console depends

on whether, during the session, you made any changes to the switch configu-

ration that require a switch reboot to activate. (Most changes via the menu

interface need only a S

ave, and do not require a switch reboot.) Configuration

changes needing a reboot are marked with an asterisk (*) next to the config-

ured item in the menu and also next to the Switch Configuration item in the

Main Menu.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General