HP ProCurve 2510-24 User Manual

B-29
Monitoring and Analyzing Switch Operation
Locating a Device
Locating a Device
If you are trying to locate a particular switch you can enter the chassislocate
command. The blue Locator LED will light up on that switch.
Figure B-24. The chassislocate command
Syntax: chassislocate [ blink | on | off ]
Locate a device by using the blue Locate LED on the front panel.
blink <1-1440>
Blinks the chassis Locate LED for a selected number of minutes
(default is 30 minutes).
on <1-1440>
Turns the chassis Locate LED on for a selected number of minutes
(default is 30 minutes).
off
Turns the chassis Locate LED off.
ProCurve(config)# chassislocate
blink <1-1440> Blink the chassis locate led (default 30 minutes).
off Turn the chassis locate led off.
on <1-1440> Turn the chassis locate led on (default 30 minutes).
ProCurve(config)# chassislocate

HP ProCurve 2510-24 Specifications

General

Model	HP ProCurve 2510-24
Switching Capacity	8.8 Gbps
Layer	Layer 2
Form Factor	Rack-mountable
MAC Address Table Size	8000 entries
Jumbo Frame Support	Yes
Power	AC 120/230 V (50/60 Hz)
Management	Web, SNMP, CLI
Features	VLAN support, QoS
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Operating Temperature	0 to 40 °C
Operating Humidity	15% to 95% (non-condensing)
Dimensions	44.25 x 17.3 x 4.45 cm