To Next Page

To Previous Page

12-12

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

SNMP Communities

SNMP commuities are supported by the switch to allow management

application that use version 2c or version 1 to access the switch. The

communities are mapped to Group Access Levels that are used for version 2c

or version 1 support. For more information see “Group Access Levels” on page

12-11. This mapping will happen automatically based on the communities

access privileges, but special mappings can be added with the snmpv3

community command.

Syntax: [no] snmpv3 community

This command maps or removes a mapping of a

community name to a group access level. To remove a

mapping you only need the

index_name.

< index < index-name >>

This is an index number or title for the mapping. The

values of 1-5 are reserved and can not be mapped.

< name < com-name >>

This is the community name that is being mapped to a

group access level

< sec-name < security-name >>

This is the group level that the community is being

mapped. For more information see “Group Access

Levels” on page 12-11.

< tag < tag-value >>

This is used to specify which target address may have

access via this index reference.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General