To Next Page

To Previous Page

9-16

Time Protocols

TimeP: Viewing, Selecting, and Configuring

• Use the Space bar to select the Manual mode.

i. Press [>] to move the cursor to the Server

Address field.

ii. Enter the IP address of the TimeP server you want the switch to

use for time synchronization.

Note: This step replaces any previously configured TimeP server

IP address.

iii. Press [>] to move the cursor to the Poll Interval field, then go to

step 6.

6. In the

Poll Interval field, enter the time in minutes that you want for a TimeP

Poll Interval.

Press

[Enter] to return to the Actions line, then [S] (for Save) to enter the new

time protocol configuration in both the startup-config and running-config

files.

CLI: Viewing and Configuring TimeP

CLI Commands Described in this Section

show timep page 9-17

[no] timesync page 9-18 ff., 9-20

ip timep

dhcp page 9-18

manual page 9-19

server <ip-addr> page 9-19

interval page 9-20

no ip timep page 9-21

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General