To Next Page

To Previous Page

9-18

Time Protocols

TimeP: Viewing, Selecting, and Configuring

Configuring (Enabling or Disabling) the TimeP Mode

Enabling the TimeP mode means to configure it for either broadcast or unicast

mode. Remember that to run TimeP as the switch’s time synchronization

protocol, you must also select TimeP as the time synchronization method by

using the CLI timesync command (or the Menu interface Time Sync Method

parameter).

Syntax: timesync timep

Selects TimeP as the time protocol.

ip timep < dhcp | manual >

Enables the selected TimeP mode.

no ip timep

Disables the TimeP mode.

no timesync

Disables the time protocol.

Enabling TimeP in DHCP Mode. Because the switch provides a TimeP

polling interval (default: 720 minutes), you need only these two commands for

a minimal TimeP DHCP configuration:

Syntax: timesync timep

Selects TimeP as the time synchronization method.

ip timep dhcp

Configures DHCP as the TimeP mode.

For example, suppose:

■ Time synchronization is configured for SNTP.

■ You want to:

1. View the current time synchronization.

2. Select TimeP as the time synchronization mode.

3. Enable TimeP for DHCP mode.

4. View the TimeP configuration.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General