To Next Page

To Previous Page

9-13

Time Protocols

SNTP: Viewing, Selecting, and Configuring

If you then viewed the SNTP configuration, you would see the following:

Figure 9-7. Example of SNTP with Time Sychronization Disabled

Disabling the SNTP Mode. If you want to prevent SNTP from being used

even if selected by timesync (or the Menu interface’s Time Sync Method param-

eter), configure the SNTP mode as disabled.

Syntax: no sntp

Disables SNTP by changing the SNTP mode

configuration to Disabled.

For example, if the switch is running SNTP in Unicast mode with an SNTP

server at 10.28.227.141 and a server version of 3 (the default),

no sntp changes

the SNTP configuration as shown below, and disables time synchronization

on the switch.

Figure 9-8. Example of Disabling Time Synchronization by Disabling the SNTP Mode

Even though the Time Sync Mode is set to Sntp,

time synchronization is disabled because no

sntp has disabled the SNTP Mode parameter.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General