HP ProCurve 2510-24 User Manual

10-5
Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
Figure 10-1. Example of the Port Status Screen
Using the Menu To Configure Ports.
Note The menu interface uses the same screen for configuring both individual ports
and port trunk groups. For information on port trunk groups, see Chapter 11,
“Port Trunking“.
1. From the Main Menu, Select:
2. Switch Configuration...
2. Port/Trunk Settings
Figure 10-2. Example of Port/Trunk Settings with a Trunk Group Configured
In this example,
ports A7 and A8
have previously
been configured
as a trunk group.

HP ProCurve 2510-24 Specifications

General

Model	HP ProCurve 2510-24
Switching Capacity	8.8 Gbps
Layer	Layer 2
Form Factor	Rack-mountable
MAC Address Table Size	8000 entries
Jumbo Frame Support	Yes
Power	AC 120/230 V (50/60 Hz)
Management	Web, SNMP, CLI
Features	VLAN support, QoS
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Operating Temperature	0 to 40 °C
Operating Humidity	15% to 95% (non-condensing)
Dimensions	44.25 x 17.3 x 4.45 cm