To Next Page

To Previous Page

12-9

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

To establish a user you must first add the user names to the list of known

users. Add user names with the snmpv3 user CLI command.

Figure 12-2. Adding and showing Users for SNMPv3

[no] snmpv3 group group_name user user_name sec-model <ver1| ver2c

| ver3>

user user_name

This is the user to be added to the access group. This

must match the user name added with the

snmpv3 user

command.

sec-model <ver1 | ver2c | ver3>

This defines which security model to use for the added

user. A SNMPv3 access Group should only use the ver3

security model.

Add user Network Admin with no

Authentication or Privacy

Add user Network Mgr with

authentication and privacy

Privacy is used and the

password is set privpass

Authentication is set to Md5

and the password is authpass

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General