To Next Page

To Previous Page

C-28

Troubleshooting

Using Logging To Identify Problem Sources

Debug Types. This section describes the types of debug messages the switch

can send to configured debug destinations.

Syntax: [no] debug < debug-type >

all

Configures the switch to send all debug types to the config-

ured debug destination(s). (Default: Disabled)

event

Configures the switch to send Event Log messages to the

configured debug destination(s). Note: This has no effect

on event notification messages the switch routinely sends

to the Event Log itself. Also, this debug type is automatically

enabled in these cases:

• If there is currently no Syslog server address configured

and you use logging < ip-addr > to configure an address.

• If there is currently at least one Syslog server address

configured and the switch is rebooted or reset.

(Default: Disabled)

port-access-auth

If 802.1x authentication is configured, this option shows

the various communication messages sent between the

switch, client, and RADIUS server.

(Default: Disabled)

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General