To Next Page

To Previous Page

C-45

Troubleshooting

Restoring a Flash Image

4. Since the OS file is large, you can increase the speed of the download by

changing the switch console and terminal emulator baud rates to a high

speed. For example:

a. Change the switch baud rate to 115,200 Bps.

=> sp 115200

b. Change the terminal emulator baud rate to match the switch speed:

i. In HyperTerminal, select Call | Disconnect.

ii. Select File | Properties.

iii. Click on Configure . . ..

iv. Change the baud rate to 115200.

v. Click on

[OK]. In the next window, click on [OK] again.

vi. Select Call | Connect

vii. Press [Enter] one or more times to display the => prompt.

5. Start the Console Download utility by typing do at the => prompt and

pressing [Enter]:

=> do

6. You will then see this prompt:

7. At the above prompt:

a. Type

y (for Yes)

b. Select Transfer | File in HyperTerminal.

c. Enter the appropriate filename and path for the OS image.

d. Select the Xmodem protocol (and not the 1k Xmodem protocol).

e. Click on [Send].

If you are using HyperTerminal, you will see a screen similar to the

following to indicate that the download is in progress:

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General