To Next Page

To Previous Page

4-14

Using the Command Line Interface (CLI)

Using the CLI

Port or Trunk-Group Context . Includes port- or trunk-specific

commands that apply only to the selected port(s) or trunk group, plus the

global configuration, Manager, and Operator commands. The prompt for this

mode includes the identity of the selected port(s):

ProCurve(config)# interface e 3-6

ProCurve(config)# interface e trk1

Command executed at

configuration level for

entering port or trk1 static

trunk-group context.

ProCurve(eth-3-6)#

ProCurve(eth-Trk1)#

Resulting prompt showing

port or static trunk

contexts.

ProCurve(eth-3-6)#?

ProCurve(eth-Trk1)#?

Lists the commands you

can use in the port or static

trunk context, plus the

Manager, Operator, and

context commands you can

execute at this level.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General