Web and MAC Authentication
Configuring Web Authentication
Specifies the time period, in seconds, the switch
enforces on a client to re-authenticate. When set to 0,
reauthentication is disabled. (Default: 300 seconds)
Syntax: aaa port-access web-based <port-list> [reauthenticate]
Forces a reauthentication of all attached clients on the
port.
Syntax: aaa port-access web-based <port-list> [redirect-url <url>]
no aaa port-access web-based <port-list> [redirect-url]
Specifies the URL that a user is redirected to after a
successful login. Any valid, fully-formed URL may be
used, for example, http://welcome-server/welcome.htm
or http://192.22.17.5. ProCurve recommends that you
provide a redirect URL when using Web Authentica-
tion.
Note: The redirect-url command accepts only the first
103 characters of the allowed 127 characters.
Use the no form of the command to remove a specified
redirect URL.
(Default: There is no default URL. Browser behavior
for authenticated clients may not be acceptable.)
Syntax: aaa port-access web-based [e] <port-list> [server-timeout <1 - 300>]
Specifies the period, in seconds, the switch waits for a
server response to an authentication request. Depend-
ing on the current max-requests value, the switch sends
a new attempt or ends the authentication session.
(Default: 30 seconds)
3-27
To Next Page
Loading...
