Web and MAC Authentication
Configuring Web Authentication
ProCurve (config)# show port-access web-based
Port Access Web-Based Status
Auth Unauth Untagged Tagged Port Cntrl
Port Clients Clients VLAN VLANs COS Dir
----- -------- -------- -------- ------ -------- -----
-
1 1 1 4006 Yes 70000000
2 2 0 MACbased No Yes
3 4 0 1 Yes No
Figure 3-8.Example of show port-access web-based Command Output
Syntax: show port-access web-based clients [port-list]
Displays the session status, name, and address for each web-
authenticated client on the switch. The IP address displayed
is taken from the DHCP binding table (learned through the
DHCP Snooping feature).
If DHCP snooping is not enabled on the switch, n/a (not
available) is displayed for a client’s IP address.
If a web-authenticated client uses an IPv6 address, n/a - IPv6
is displayed.
If DHCP snooping is enabled but no MAC-to-IP address
binding for a client is found in the DHCP binding table, n/a
- no info is displayed.
ProCurve (config)# show port-access web-based clients
Port Access Web-Based Client Status
Port Client Name MAC Address IP Address Session Status
----- ------------ ------------- --------------- ------------
-
1 webuser1 0010b5-891a9e 192.192.192.192 Authenticated
1 webuser2 001560-b3ea48 n/a - no info Authenticating
1 webuser3 000000-111111 n/a - IPv6 Authenticating
3 webuser4 000000-111112 n/a Authenticating
Figure 3-9. Example of show port-access web-based clients Command Output
3-29
To Next Page
Loading...
Need help?
General