5-18
Configuring IP Addressing, Interface Access, and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
Configuring IP Addressing,
Interface Access, and
CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
Listing the Current Console/Serial Link Configuration. This com-
mand lists the current interface access parameter settings.
Syntax: show console
This example shows the switch’s default console/serial configuration.
Figure 5-5. Listing of Show Console Command
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax:[no] telnet-server
To disable inbound Telnet access:
HP2512(config)# no telnet-server
To re-enable inbound Telnet access:
HP2512(config)# telnet-server
show console below
[no] telnet-server below
[no] web-management page 5-19
console page 5-19
Interface Access
Enable/Disable
Console Control
Options
Event Log Event
Types To List
To Next Page
Loading...
