HP ProCurve series 2500 User Manual

C-2
Switch Memory and Configuration
Overview
Switch Memory and
Configuration
Overview
This appendix describes the following:
■ How switch memory manages configuration changes
■ How the CLI implements configuration changes
■ How the menu interfaceand web browser interface implement configura-
tion changes
Overview of Configuration File
Management
The switch maintains two configuration files, the running-config file and the
startup-config file.
Figure C-10. Conceptual Illustration of Switch Memory Operation
■ Running Config File: Exists in volatile memory and controls switch
operation. If no configuration changes have been made in the CLI since
the switch was last booted, the running-config file is identical to the
startup-config file.
■ Startup-config File: Exists in flash (non-volatile) memory and is used
to preserve the most recently-saved configuration as the "permanent"
configuration.
Running-Config File
(Controls switch operation. When the switch reboots,
the contents of this file are erased and replaced by the
contents of the startup-config file.)
Startup-Config File
(Preserves the most recently saved configuration
through any subsequent reboot.)
Volatile Memory
Flash (Non-Volatile) Memory
CLI configuration
changes are written to
this file. To use the CLI to
save the latest version of
this file to the startup-
config file, you must
execute the write
memory command.
Menu interface configu-
ration changes are simul-
taneously written to both
of these files.

HP ProCurve series 2500 Specifications

General

Brand	HP
Model	ProCurve series 2500
Category	Switch
Language	English