9-86
Configuring Advanced Features
GVRP
Configuring Advanced
Features
CLI: Viewing and Configuring GVRP
GVRP Commands Used in This Section
Displaying the Switch’s Current GVRP Configuration. This command
shows whether GVRP is disabled, along with the current settings for the
maximum number of VLANs and the current Primary VLAN. (For more on the
last two parameters, see “Port-Based Virtual LANs (Static VLANs)” on page
9-50.)
Syntax: show gvrp
Figure 9-62. Example of “Show GVRP” Listing with GVRP Disabled
Figure 9-63. Example of Show GVRP Listing with GVRP Enabled
show gvrp below
gvrp page 9-87
unknown-vlans page 9-87
This example includes
non-default settings for
the Unknown VLAN field
for some ports.
To Next Page
Loading...
Need help?
General