HP ProCurve series 2500 User Manual

3-15
Using the Command Line Interface (CLI)
Using the CLI
Using the Command Line
Interface (CLI)
VLAN Context . Includes VLAN-specific commands that apply only to the
selected VLAN, plus Manager and Operator commands. The prompt for this
mode includes the VLAN ID of the selected VLAN. For example, if you had
already configured a VLAN with an ID of 100 in the switch:
Figure 3-11. Context-Specific Commands Affecting VLAN Context
HP2512(config)# vlan 100 Command executed at configura-
tion level to enter VLAN 100
context.
HP2512(vlan-100)# Resulting prompt showing VLAN
100 context.
HP2512(vlan-100)# ? Lists commands you can use in the
VLAN context, plus Manager, Oper-
ator, and context commands you
can execute at this level.
In the VLAN
context, the
first block of
commands in
the "?" listing
show the
commands that
will affect only
vlan-100.
The remaining
commands in
the listing are
Manager,
Operator, and
context
commands.

HP ProCurve series 2500 Specifications

General

Brand	HP
Model	ProCurve series 2500
Category	Switch
Language	English