HP ProCurve series 2500 User Manual

9-67
Configuring Advanced Features
Port-Based Virtual LANs (Static VLANs)
Configuring Advanced
Features
Converting a Dynamic VLAN to a Static VLAN. If GVRP is running on
the switch and a port dynamically joins a VLAN, you can use the next
command to convert the dynamic VLAN to a static VLAN. (For GVRP and
dynamic VLAN operation, see “GVRP” on page 9-77.) This is necessary if you
want to make the VLAN permanent. Note that after you convert a dynamic
VLAN to static, you must configure the switch’s per-port participation in the
VLAN in the same way that you would for any static VLAN.
Syntax: static-vlan <vlan-id>
If you need a VID reference, use show vlan to list the switch’s currently existing
VLANs.
For example, suppose a dynamic VLAN with a VID of 125 exists on the switch.
The following command converts the VLAN to a static VLAN.
HP2512(config)# static-vlan 125
Configuring Static VLAN Name and Per-Port Settings. The vlan <vlan-
id> command, used in conjunction with the options listed below, enables you
to change the name of an existing static VLAN and change the per-port VLAN
membership settings as show below.
Note You can use these options from the configuration level by beginning the
command with vlan <vlan-id>, or from the context level of the specific VLAN.
Syntax: name <vlan-name> Changes the name of the existing
static VLAN. (No spaces allowed in the
<vlan-name> entry.
[no] tagged <port-list> Configures the indicated port(s) as
Tagged for the specified VLAN. The
“no” version sets the port(s) to
either No or (if GVRP is enabled) to Auto.
[no] untagged <port-list> Configures the indicated port(s) as
Untagged for the specified VLAN. The
“no” version sets the port(s) to
either No or (if GVRP is enabled) to Auto.
[no] forbid <port-list> Configures the indicated port(s) as
“forbidden” to participate in the
designated VLAN. The “no” version sets
the port(s) to either No or (if GVRP is
enabled) to Auto.
auto <port-list> Available if GVRP is enabled on the
switch. Returns the per-port settings
for the specified VLAN to Auto

HP ProCurve series 2500 Specifications

General

Brand	HP
Model	ProCurve series 2500
Category	Switch
Language	English