EasyManuals Logo

HP ProOne 400 G1 User Manual

HP ProOne 400 G1
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
Table 10-2 Diagnostic front panel LEDs and audible codes (continued)
Activity Beeps Possible Cause Recommended Action
Red Power LED flashes nine
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue until
problem is solved.
9 System powers on but is
unable to boot.
1. Unplug the AC power cord from the
computer, wait 30 seconds, then plug the
power cord back in to the computer.
2. Replace the system board.
3. Replace the processor.
Red Power LED flashes eleven
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue until
problem is solved.
11 The current processor does
not support a feature
previously enabled on this
system.
1. Install a TXT capable processor.
2. Disable TXT in the Computer Setup (F10)
utility.
3. Reinstall the original processor.
Red Power LED flashes eleven
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue until
problem is solved.
12 MXM thermal shutdown. 1. Clean the MXM graphics card heat sink.
2. Replace the MXM graphics card heat sink.
3. Replace the MXM graphic card.
System does not power on and
LEDs are not flashing.
None System unable to power
on.
Press and hold the power button for less than 4
seconds. If the hard drive LED turns green, the
power button is working correctly. Try the
following:
1. Replace the system board.
OR
Press and hold the power button for less than 4
seconds. If the hard drive LED does not turn on
green then:
1. Check that the unit is plugged into a
working AC outlet.
2. Open rear cover and check that the power
button cable is properly connected to the
system board.
3. Check to see if the 5V_aux light on the
system board is turned on. If it is turned on,
then replace the power button board and
cable. If the problem persists, replace the
system board.
4. Replace the AC adapter.
Interpreting POST diagnostic front panel LEDs
159

Table of Contents

Other manuals for HP ProOne 400 G1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProOne 400 G1 and is the answer not in the manual?

HP ProOne 400 G1 Specifications

General IconGeneral
Full HDNo
Panel typeTN
LED backlightYes
Display diagonal21.5 \
Display resolution- pixels
Native aspect ratio-
Tcase72 °C
Bus typeDMI
Processor cache3 MB
Processor cores2
Processor modeli3-4130T
System bus rate5 GT/s
Processor familyIntel® Core™ i3
Processor seriesIntel Core i3-4100 Desktop series
Processor socketLGA 1150 (Socket H3)
Processor threads4
Processor codenameHaswell
Number of QPI links0
Processor frequency2.9 GHz
Processor cache typeSmart Cache
Processor lithography22 nm
Processor manufacturerIntel
Processor front side bus- MHz
PCI Express slots version3.0
Processor operating modes32-bit, 64-bit
PCI Express configurations2x8
Thermal Design Power (TDP)35 W
Maximum number of PCI Express lanes16
Memory types supported by processorDDR3-SDRAM
Memory channels supported by processorDual
Memory clock speeds supported by processor1333, 1600 MHz
Memory bandwidth supported by processor (max)25.6 GB/s
Maximum internal memory supported by processor32 GB
Product typeAll-in-One PC
Motherboard chipsetIntel® H81
Internal memory4 GB
Memory slots typeSO-DIMM
Memory clock speed1600 MHz
Maximum internal memory- GB
Memory layout (slots x size)1 x 4 GB
HDD speed7200 RPM
HDD interfaceSATA
Storage mediaHDD
Optical drive typeDVD Super Multi
Total storage capacity500 GB
Intel segment taggingEnterprise, Professional
Storage drive interfaceSerial ATA
On-board graphics card ID0x41E
Discrete graphics card modelNot available
On-board graphics card modelIntel® HD Graphics 4400
On-board graphics card familyIntel® HD Graphics
Maximum on-board graphics card memory1.74 GB
On-board graphics card base frequency200 MHz
On-board graphics card DirectX version11.1
On-board graphics card dynamic frequency (max)1150 MHz
Number of displays supported (on-board graphics)3
Wi-Fi standardsNot supported
Ethernet LAN data rates10, 100, 1000 Mbit/s
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Operating system installedWindows 8.1 Pro
Operating system architecture64-bit
Scalability1S
Processor ARK ID77481
Processor package size37.5 x 37.5 mm
Supported instruction setsAVX 2.0
Thermal solution specificationPCG 2013A
Intel Small Business Advantage (SBA) version1.00
Intel Stable Image Platform Program (SIPP) version0.00
Product colorBlack
Country of originChina
Total megapixels- MP
AC adapter power120 W
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)15 - 80 %
Sustainability certificatesENERGY STAR
Weight and Dimensions IconWeight and Dimensions
Package width7420 mm
Depth (with stand)59.4 mm
Width (with stand)557.9 mm
Height (with stand)362.9 mm
Weight (with stand)5070 g

Related product manuals