HP ProOne 400 G1 - Removing a 2.5-Inch Solid State Drive (SSD), Self-Encrypting Drive (SED), or Solid State Hybrid Drive (SSHD)

6. Slide the 3.5-inch hard drive out of the hard drive cage (2).
For instructions on installing a hard drive, see Installing a hard drive on page 38.
Removing a 2.5-inch solid state drive (SSD), self-encrypting drive (SED), or solid state hybrid
drive (SSHD)
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Remove the rear cover (see
Rear cover on page 30).
The hard drive cage can now be seen in the lower left side of the chassis.
3. Loosen the captive screw securing the hard drive cage in the chassis (1).
36 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis