To avoid the risk of electric shock:
● The battery-charger assembly should be connected to earthed mains outlets only.
● Always use the battery charger in indoor locations.
● Do not attempt to dismantle the battery charger or power module.
● Do not manipulate the power module or power cord. If you detect any imperfection, contact your
service representative for assistance or change of component.
● Do not use electrical components not supplied with the robot.
● Do not try to use the battery charger for any purpose other than charging the robot battery.
Heat hazard
Take care when touching the external enclosure or handling the robot after long exposure to outdoor
high temperatures.
To avoid personal injury, let the robot cool down before performing internal maintenance operations.
Fire hazard
The customer is responsible for meeting the robot’s requirements and the Electrical Code requirements
according to the local jurisdiction of the country where the equipment is installed.
To avoid the risk of fire, take the following precautions:
● Use only the battery supplied with the robot.
● To charge the battery, use only the charger supplied with the robot.
● Do not use damaged components of the charger (power cord, power module, or the charger itself).
Do not use the charger with other products.
● Ensure that the battery-charger power module is suitable for the power source to which it will be
connected.
● When charging or removing the battery, try to avoid particles or liquid entering the battery
compartment or charger.
● Do not operate the robot outdoors when it is raining.
● When closing the battery compartment, make sure it is fully closed, to keep out liquids and dust.
● Use the robot within its specified operating and storage ranges of temperature, humidity, and
altitude.
● Do not insert objects through slots or doors in the robot.
● Take care not to spill liquid on the robot. After cleaning according to the maintenance instructions,
make sure all components are dry before using the robot again. If a significant amount of liquid has
entered the robot, contact your service representative.
● Do not clean the robot with pressurized water or a large quantity of water or other liquids. Follow the
HP recommendations.
4
Chapter 1 Introduction
To Next Page
Loading...
