● Check the air filters regularly in accordance with the instructions in this guide, cleaning them
if necessary. Do not remove the filters: if you think they should be removed, call your service
representative.
● Do not use aerosol products that contain flammable gases inside or around the robot. Do not
operate the robot in an explosive atmosphere.
● Do not block or cover the openings of the robot.
● Do not open the robot or manipulate anything inside it. The robot may use ethanol-based inks, which
could cause a risk of fire if they leak.
● Follow all maintenance instructions.
● Proper maintenance and genuine HP consumables are required to ensure that the robot operates
safely as designed. The use of non-HP consumables may present a risk of fire.
Explosion hazard
To avoid the risk of explosion, take the following precautions.
WARNING! Ink-based ethanol leakages and especially vapors can be explosive in air in some
concentrations. Take precautionary measures against static charges, and keep the robot away from
sources of ignition.
WARNING! Remove the battery from the robot before putting the robot into its case for
transportation, and before starting any maintenance procedure.
NOTICE: The equipment is not intended for hazardous locations or ATEX classified zones: ordinary
locations only.
● Follow all maintenance instructions promptly, as needed (cleaning, filter replacement, ink-circuit
purge, and so on).
● Smoking, candles, welding, hot surfaces, and open flames should be forbidden close to the
equipment and the ink-supply storage area.
● Avoid working in areas with powerful radio frequencies or electromagnetic fields in general.
● Do not work in areas where sparks can fly.
● Do not open the robot or manipulate it internally. Internal ink leakages or ink-vapor emissions,
combined with the generation of ESD (ElectroStatic Discharges) inside the ink-circuit pipes and
fittings when removed or generated from contact with people, could create an explosion or fire risk.
● Use HP recommended inks only. Do not use unauthorized third-party inks.
● In case of ink leaks, all personnel should be freed from static electricity by discharging it before
handling the robot.
● Stop operation, remove the battery, and contact your service representative if any ink leak is
detected.
Mechanical hazard
The robot has moving parts that could cause injury.
Explosion hazard
5
To Next Page
Loading...
