HP Vizualize,Visualize b2000 - Page 58

58 Chapter 3
Troubleshooting
Selftest Failures
TST 2
n
90 SYS BD CPU n dcache ECC
CPU n is starting its data cache ECC
self-test.
FLT 2BAD SYS BD assertion fail
A firmware assertion failed.
TST 3
n
00 SYS BD ROM checksum tst
Monarch CPU n is testing the boot ROM
integrity.
FLT 3
n
00 SYS BD ROM checksum BAD
The boot ROM failed checksum.
INI 3
n
00 SYS BD ROM checksum ok
The boot ROM passed checksum.
TST 3
n
01 SYS BD PDH control test
Monarch CPU n is testing PDH control
register.
INI 3
n
01 SYS BD PDH control init
Monarch CPU n is initializing the PDH
control register.
FLT 3
n
01 SYS BD PDH control err
Monarch CPU n detected an error in the
PDH control register.
TST 3
n
02 SYS BD scratch RAM test
Monarch CPU n is testing scratch RAM.
INI 3
n
02 SYS BD scratch RAM ok
The scratch RAM test failed.
FLT 3
n
02 SYS BD scratch RAM bad
The scratch RAM test passed.
WRN 3
n
03 SYS BD stbl st read err
CPU n detected a non-fatal error reading
the stable store.
FLT 3
n
03 SYS BD stbl st read err
CPU n detected a non-fatal error reading
the stable store.
INI 3
n
C4 SYS BD clearing EEPROM
Monarch CPU n is clearing the EEPROM.
INI 3
n
D4 SYS BD deflting EEPROM2
Monarch CPU n is initializing the
EEPROM to system defaults.
WRN 3
n
04 SYS BD EEPROM write err
CPU n detected a non-fatal error writing
the EEPROM.
FLT 3
n
04 SYS BD EEPROM write err
CPU n detected a fatal error writing the
EEPROM.
FLT 3
n
05 SYS BD EEPROM wrt limit
CPU n detected a fatal error writing the
EEPROM.
WRN 3
n
06 SYS BD EEPROM read err
CPU n detected a non-fatal error reading
the EEPROM.
FLT 3
n
06 SYS BD EEPROM read err
CPU n detected a fatal error reading the
EEPROM.
INI 3
n
07 SYS BD
CPU
n
invoke LDB CPU n is starting the low-level debugger.
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU Message
Description