HP ZBook Fury G11 - Page 97

16. To replace the ambient light sensor (ALS) module cable:
a. Disconnect the ALS module cable (1) from the ALS module.
b. Disconnect the ALS module cable (2) from the display hub board.
c. Detach the ALS module cable (3) from the display back cover. The cable is attached with
double-sided adhesive.
The ALS module cable is included in the Display Cable Kit, spare part number N99102-001.
17. To replace the ambient light sensor (ALS) module:
a. Remove the two Phillips M1.5 × 2.1 screws (1) that secure the ALS module to the display back
cover.
b. Remove the ALS module (2) from the display back cover.
The ALS module is available using spare part number N99101-001.
Display assembly
87