HPE 5510 HI Series

35
Step
Description
 Planning the cabling scheme
2. Install IRF member
switches
See "Installing the switch in a 19-inch rack" or "Mounting the switch on a
workbench."
3. Connect ground wires
and power cords
See "Grounding the switch" and "Connecting the power cord."
4. Power on the switches
N/A
5. Configure basic IRF
settings
See HPE 5510 HI Switch Series IRF Configuration Guide.
6. Connect the physical
IRF ports
Connect physical IRF ports on switches. Use SFP+/QSFP+ transceiver modules
and fibers to connect 10-Gigabit SFP+ ports/40-Gigabit QSFP+ ports over a
long distance, or use SFP+/QSFP+ DAC cables to connect 10-Gigabit SFP+
ports/40-Gigabit QSFP+ ports over a short distance.
All switches except the master switch automatically reboot, and the IRF fabric is
established.
Planning IRF fabric setup
This section describes issues that an IRF fabric setup plan must cover.
Planning IRF fabric size and the installation site
Choose switch models and identify the number of required IRF member switches, depending on the user
density and upstream bandwidth requirements. The switching capacity of an IRF fabric equals the total
switching capacities of all member switches.
Plan the installation site depending on your network solution, as follows:
 Place all IRF member switches in one rack for centralized high-density access.
 Distribute the IRF member switches in different racks to implement the ToR access solution for a data
center.
NOTE:
For the maximum IRF member devices supported by the HPE 5510 HI, see the release notes that come with
the switch.
Identifying the master switch and planning IRF member IDs
Determine which switch you want to use as the master for managing all member switches in the IRF
fabric.
An IRF fabric has only one master switch. You configure and manage all member switches in the IRF
fabric at the CLI of the master switch. IRF member switches automatically elect a master.
You can affect the election result by assigning a high member priority to the intended master switch. For
more information about master election, see HPE 5510 HI Switch Series IRF Configuration Guide.