HPE 5510 HI Series

59
NOTE:
USB devices from different vendors vary in compatibilities and drivers. HPE does not guarantee the correct
operation of USB devices from all vendors on the switch. If a USB device fails to operate on the switch,
replace it with one from another vendor.
10/100/1000Base-T autosensing Ethernet port
Table 16 10/100/1000Base-T autosensing Ethernet port specifications
Item
Specification
Connector type
RJ-45
Interface attributes
 10 Mbps, full duplex
 100 Mbps, full duplex
 1000 Mbps, full duplex
 MDI/MDI-X, auto-sensing
Max transmission
distance
100 m (328.08 ft)
Transmission medium
Category-5 (or above) twisted pair cable
Standards
IEEE 802.3i, 802.3u, 802.3ab
100/1000Base-X SFP port
The HPE 5510 24G SFP 4SFP+ HI switch provides 24 fixed SFP ports on the front panel. You can install
the 100 Mbps SFP modules in Table 17 and the 1000 Mbps SFP transceiver modules in Table 18 in the
SFP ports.
Table 17 100 Mbps SFP transceiver modules available for the 100/1000 Base-X SFP ports
Product
code
HPE description
Central
wavelength
(nm)
Connector
Fiber diameter (µm)
Max
transmission
distance
JD102B
HP X115 100M SFP
LC FX Transceiver
1310
LC
Multi-mode, 50/125
2 km (1.24
miles)
Multi-mode, 62.5/125
JD120B
HP X110 100M SFP
LC LX Transceiver
1310
LC
Single-mode, 9/125
15 km (9.32
miles)
JD090A
HP X110 100M SFP
LC LH40 Transceiver
1310
LC
Single-mode, 9/125
40 km (24.86
miles)
JD100A
HP X110 100M SFP
LC BX 10-U
Transceiver
TX: 1310
RX: 1550
LC
9/125
15 km (9.32
miles)
JD101A
HP X110 100M SFP
LC BX 10-D
TX: 1550
RX: 1310
LC
9/125
15 km (9.32
miles)