HPE 5510 HI Series

50
HPE 5510 48G PoE+ 4SFP+ HI
Figure 53 HPE 5510 48G PoE+ 4SFP+ HI front panel
(1) 10/100/1000Base-T autosensing Ethernet port
(2) 10/100/1000Base-T autosensing Ethernet port LED
(3) Management Ethernet port
(4) Console port
(5) USB mini console port
(6) Port LED mode switching button
(7) USB port
(8) System status LED (SYS)
(9) SFP+ port
(10) Port mode LED
(11) Interface card status LED (SLOT)
(12) Power supply 2 status LED (PWR2)
(13) Power supply 1 status LED (PWR1)
(14) SFP+ port LED
(15) Management Ethernet port LED
Figure 54 HPE 5510 48G PoE+ 4SFP+ HI rear panel
(1) Grounding screw
(2) Interface card
(3) Fan tray 1
(4) Fan tray 2
(5) Power supply 1
(6) Power supply 2
The HPE 5510 48G PoE+ 4SFP+ HI switch comes with power supply slot 1 empty and power supply slot
2 installed with a filler panel. You can install one or two power supplies for the switch as required. In this
figure, two PSR720-56A AC power supplies are installed in the power supply slots. For more
information about installing and removing a power supply, see "Installing/removing a power supply."
The HPE 5510 48G PoE+ 4SFP+ HI switch comes with a filler panel in the interface card slot. You can
select an interface card for the switch as required. In this figure, an LSWM2SP2PM interface card is
installed in the interface card slot. For more information about installing and removing an interface card,
see "Installing/removing an interface card."
1
3 4 5 6
7
2
11
14
15
10
12
13
8
9
1
2 3 4 5 6