HPE 5510 HI Series

65
LED mark
Status
Description
Steady red
The switch has failed the POST or is faulty.
Flashing yellow (1 Hz)
Some ports have failed to pass POST or are faulty.
Off
The switch is powered off.
Power supply status LED
The switch provides two power supply slots at the rear. For each power supply, the switch provides a
power supply status LED on the front panel.
Table 25 Power supply status LED description
LED mark
Status
Description
PWR1
Steady green
A power supply is installed in power supply slot 1, and the power
supply is outputting power correctly.
Steady yellow
A power supply is installed in power supply slot 1, but the power
supply has failed or no power is input to the power supply.
Off
No power supply is installed in power supply slot 1.
PWR2
Steady green
A power supply is installed in power supply slot 2, and the power
supply is outputting power correctly.
Steady yellow
A power supply is installed in power supply slot 2, but the power
supply has failed or no power is input to the power supply.
Off
No power supply is installed in power supply slot 2.
Port mode LED
To show more information about the switch through the port status LEDs, all HPE 5510 HI switches
provides a port mode LED. The port mode LED indicates the type of information that the network port
LEDs are showing.
Table 26 Port mode LED description
LED mark
Status
Description
Mode
Steady green
The port status LEDs are showing
port rates.
Flashing green (1 Hz) (available only for HPE 5510
24G PoE+ 4SFP+ HI and HPE 5510 48G PoE+
4SFP+ HI switches)
The port status LEDs are showing the
status of PoE power supply on the
ports.
Flashing yellow
The port status LEDs indicates the IRF
member ID of the switch. For
example, if the LEDs for ports 1 to 5
are steady green and the other LEDs
are off, the IRF member ID of the
switch is 5.