HPE 5510 HI Series - Page 80

75
setting terminal parameters, 32
setting up IRF fabric, 34
technical specifications, 46
verifying installation, 27
workbench mounting switch, 14
system administration
troubleshooting configuration terminal
problems, 44
troubleshooting fan failure, 42
troubleshooting hot swappable fan failure, 42
troubleshooting power supply failure, 42
system status LED, 64
T
technical specifications, 51
10/100/1000 Base-T autosensing Ethernet
port, 59
10/100/1000 Base-T autosensing Ethernet
port LED, 66
combo interface, 64
console port, 58
fan tray status LED, 68
interface card, 56
interface card port status LED, 68
interface card status LED, 68
LED, 64
management Ethernet port, 58
management Ethernet port LED, 67
port, 58
port mode LED, 65
power supply, 55
power supply input status, 68
power supply output status, 68
power supply status LED, 65
QSFP+ port, 62
SFP port, 59
SFP port LED, 66
SFP+ port, 60
SFP+ port LED, 67
system status LED, 64
USB port, 58
temperature
installation site requirements, 2
terminal
troubleshooting garbled terminal display, 44
troubleshooting no terminal display, 44
tools needed for installation, 4
topology
planning IRF cabling scheme, 37, 37
topology (IRF fabric), 36
troubleshooting
configuration terminal problems, 44
fan failure, 42
garbled terminal display, 44
hot swappable fan failure, 42
no terminal display, 44
power supply failure, 42
U
USB
port, 58
V
verify the IRF fabric setup, 41 , 42
verifying
IRF fabric setup, 41, 42
switch installation, 27
VT100, 32
W
workbench
mounting switch, 14